FQXSFMA0001M : DIMM [arg1] has been disabled due to an error detected during POST.

DIMM [arg1] has been disabled due to an error detected during POST.

Severity

Error

User Response

Complete the following steps:
  1. If the DIMM was disabled because of a memory fault, follow the procedure for that event.
  2. If no memory fault is recorded in the logs and no DIMM connector error LEDs are lit, re-enable the DIMM through the Setup utility or the OneCLI utility.
  3. If problem persists, Power cycle the compute node from the management console.
  4. Reset BMC to default settings.
  5. Reset UEFI to default settings.
  6. Update BMC and UEFI firmware.
  7. Replace the system board.
  8. NOTE: Additional information about V10/V20/V30
    1. V10: All DIMMs in the system are qualified including the failing DIMM
    2. V20: The failing DIMM is unqualified
    3. V30: The failing DIMM is qualified but the system contains non-failing unqualified DIMMs