Install the enclosure cover

Use this information to install the enclosure cover.

About this task

To avoid possible danger, read and follow the following safety statement.
  • S014
    shock hazard
    CAUTION:
    Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
  • S033
    240VA shock hazard
    CAUTION:

    Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Attention: Read the Installation guidelines to ensure that you work safely.
Watch the procedure. A video of the installation process is available:

Procedure

Install the enclosure cover into the enclosure.
  1. Insert the enclosure cover tabs into the slots on the enclosure; then, rotate the enclosure cover inwards.
  2. Use Phillips #1 screwdriver to fasten the three captive screws on the enclosure cover.
    Figure 1. Enclosure cover installation
    Enclosure cover installation

After you finish

  1. Install the solution back to the rack if necessary.

  2. Reconnect power cords and all external cables.

  3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate the node is ready to be powered on.