Install the node front cover

Use this information to install the node front cover.

About this task

To avoid possible danger, read and follow the following safety statement.
  • S014
    shock hazard
    CAUTION:
    Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
  • S033
    240VA shock hazard
    CAUTION:

    Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Attention: Read the Installation guidelines to ensure that you work safely.
Watch the procedure. A video of the installation process is available:

Procedure

Figure 1. Node front cover installation
Node front cover installation

Install the node front cover into the compute node.
  1. Align the pins on the inside of the node front cover with the notches in the side walls of the compute node. Then, position the cover on top of the node and slide the cover forward until it latches in place.
  2. Fasten the screw on the node front cover.

After you finish

  1. Reinstall the compute node into the enclosure (see Install a compute node in the enclosure).
  2. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate the node is ready to be powered on.