System Management Module 2 (SMM2)

The following illustration shows the connectors and LEDs on the rear of the System Management Module 2 (SMM2).

Figure 1. SMM2 connectors and LEDs
SMM2 connectors and LEDs
Table 1. SMM2 connectors and LEDs
1 Ethernet port 1 and port 2 link (RJ-45) LED (green) 7 Check log LED (yellow)
2 Ethernet port 1 and port 2 activity (RJ-45) LED (green) 8 Identification LED (blue)
3 USB connector 9 USB port service mode button
4 Reset pinhole 10 Ethernet port 2
5 Power LED (green) 11 Ethernet port 1
6 Status LED (green)  

1 Ethernet port 1 and port 2 link (RJ-45) LED (green): When this LED is lit (green), it indicates that there is an active connection through the remote management and console (Ethernet) port 1 and port 2 to the management network.

2 Ethernet port 1 and port 2 activity (RJ-45) LED (green): When this LED is flashing (green), it indicates that there is an activity through the remote management and console (Ethernet) port 1 and port 2 over the management network.

3 USB connector: Insert the USB storage device to this connector and then press the USB port service mode button to collect FFDC logs.

4 Reset pinhole: Press the button for one to four seconds, SMM2 reboots. Press over four seconds, SMM2 reboots and loads to the default settings.

5 Power LED: When this LED is lit (green), it indicates that the SMM2 has power.

6 Status LED: This LED (green) indicates the operating status of the SMM2.

7 Check log LED: When this LED is lit (yellow), it indicates that a system error has occurred. Check the SMM2 event log for additional information.

8 Identification LED: When this LED is lit (blue), it indicates the enclosure location in a rack.

9 USB port service mode button: Press this button to collect FFDC logs after inserting the USB storage device to the USB connector.

10 Ethernet port 2: Use this connector to access SMM2 management.

11 Ethernet port 1: Use this connector to access SMM2 management.