Install the external LCD diagnostics handset

Follow instructions in this section to install the external LCD diagnostics handset.

About this task

To avoid possible danger, read and follow the following safety statement.
  • S014
    shock hazard
    CAUTION:
    Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
  • S017
    moving parts
    CAUTION:
    Hazardous moving fan blades nearby. Keep fingers and other body parts away.
  • S033
    240VA shock hazard
    CAUTION:

    Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

About this task

Attention:
  • Read the Installation guidelines to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the solution; then, remove it from the package and place it on a static-protective surface.

Watch the procedure. A video of the installation process is available:

Procedure

  1. Align the connector on the cable with that on the compute node and push it in.
    Figure 1. Connecting the external LCD diagnostics handset cable Connecting the external LCD diagnostics handset cable
  2. Attach the external LCD diagnostics handset to a metal surface with the magnetic bottom.
    Figure 2. Attaching the external LCD diagnostics handset to a metal surface
    Attaching the external LCD diagnostics handset to a metal surface

After you finish

Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate the node is ready to be powered on.