Install an adapter

Use this information to install an adapter.

Before you install an adapter:
  1. Read the following section(s) to ensure that you work safely.
Note:

If the ThinkSystem Mellanox ConnectX-6 HDR/200GbE QSFP56 1-port PCIe VPI Adapter (Shared IO) is installed, make sure that you install the adapters correctly as the following illustration.

There are two cables come with the Auxiliary adapter, make sure that you connect these two cables to the Shared IO adapter as the following illustration.

Figure 1. ConnectX-6 adapter (Shared IO)
ConnectX-6 adapter (Shared IO)
1 Shared IO adapter 3 Auxiliary adapter
2 Slim-Line 8I SAS cable  

Complete the following steps to remove an adapter.

Watch the procedure. A video of the installation process is available:

  1. Align the adapter with the PCIe slot on the riser-cage. Then, carefully press the adapter straight into the slot until it is securely seated.
    Figure 2. Adapter installation
    Adapter installation
  2. Install the PCIe riser assembly.
    1. Align the heat pipe extending from the PCIe riser assembly with the trough in the conduction plate.
    2. Orient the PCIe riser assembly above the connector.
    3. Press the PCIe riser assembly firmly into the node.
      Figure 3. PCIe riser-cage assembly installation
      PCIe riser-cage assembly installation
    4. Slide the retaining clamp underneath the heat pipe; then, rotate the clamp over the heat pipe in the trough.
    5. Secure the clamp by inserting and tightening two silver Torx T10 screws.
      Figure 4. Screws and retaining clamp installation
      Screws and retaining clamp installation

After you install an adapter, complete the following steps:

  1. Reinstall the tray cover (see Install the tray cover).

  2. Reinstall the tray (see Install a DWC tray in the enclosure).

  3. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate both nodes are ready to be powered on.