Introduction

The ThinkSystem SD650 Dual Node DWC Tray Type 7X58 and NeXtScale n1200 DWC Enclosure Type 5468 is a 6U solution designed for high-volume network transaction processing. This solution includes a single enclosure that can contain up to six SD650 trays, which are designed to deliver a dense, scalable platform for distributed enterprise and hyperconverged solutions.

Figure 1. Enclosure with sixThinkSystem SD650 trays installed
Enclosure with six ThinkSystem SD650 trays installed

Helpful links

You might find the following links helpful:
Warranty Lookup Lenovo ServerProven Software and Operating Systems
Lenovo Product Guides (Lenovo Press) Lenovo Configuration and Options Guide Drivers and Software Downloads
Lenovo Support Lenovo Forums Drivers and Firmware Updates Best Practices
Lenovo Security Advisories Lenovo Open Source Projects Lenovo License Information Documents
Lenovo Privacy Statement Lenovo Service Request (Submit An eTicket)  

Initial setup

To install the server, perform the following steps after unpacking the server:

The solution setup procedure varies depending on the configuration of the solution when it was delivered. In some cases, the solution is fully configured and you just need to connect the solution to the network and an ac power source, and then you can power on the solution. In other cases, the solution needs to have hardware options installed, requires hardware and firmware configuration, and requires an operating system to be installed.

The following steps describe the general procedure for setting up a solution:

  1. Unpack the solution package. See Solution package contents.

  2. Set up the solution hardware.

    1. Install any required hardware or solution options. See the related topics in Install solution hardware options.

    2. If necessary, install the solution into a standard rack cabinet by using the rail kit shipped with the solution. See the Rack Installation Instructions that comes with optional rail kit.

    3. Connect the Ethernet cables and power cords to the solution. See Rear view to locate the connectors. See Cable the enclosure for cabling best practices.

    4. Power on the solution. See Power on nodes.
      Note:

      You can access the management processor interface to configure the system without powering on the solution. Whenever the solution is connected to power, the management processor interface is available. For details about accessing the management node processor, see:

      XClarity Controller web interface

    5. Validate that the solution hardware was set up successfully.

  3. Configure the system.

    1. Connect the Lenovo XClarity Controller to the management network. See Set the network connection for the Lenovo XClarity Controller.

    2. Update the firmware for the solution, if necessary. See Update the firmware.

    3. Configure the firmware for the solution. See Configure the firmware.

      The following information is available for RAID configuration:

    4. Install the operating system. See Install the operating system.

    5. Back up the solution configuration. See Back up the solution configuration.

    6. Install the applications and programs for which the solution is intended to be used.