Remove the tray cover

Use this information to remove the tray cover.

S014
shock hazard
CAUTION:
Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
S033
240VA shock hazard
CAUTION:

Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Before you remove the tray cover:

  1. Read the Installation Guidelines to ensure that you work safely.

  2. Turn off the corresponding DWC tray that you are going to perform the task on.

  3. Remove the tray out of the enclosure (see Remove a DWC tray from the enclosure).

Complete the following steps to remove the tray cover.

Watch the procedure. A video of the installation process is available:

  1. Press on the release latch and the push point at the same time and slide the cover toward the rear of the DWC tray.
    Figure 1. Tray cover removal
    Tray cover removal
  2. Lift the cover off the DWC tray and set it aside.
    Note: Service label instructions are located on the underside of each tray cover.

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.