Remove an Internal Faceplate Transition (IFT) adapter

Use this information to remove an IFT adapter.

Before you remove an IFT adapter:
  1. Read the following section(s) to ensure that you work safely.
  2. Turn off the corresponding DWC tray that you are going to perform the task on.

  3. Remove the tray (see Install a DWC tray in the enclosure).

  4. Remove the tray cover (see Remove the tray cover).

  5. Remove the drive cage (see Remove a drive cage assembly).

Complete the following steps to remove an IFT adapter.

Watch the procedure. A video of the installation process is available:

  1. Rotate the IFT connector release spring up and away from the cable side of the connector; then, disconnect the IFT connector.
    Figure 1. Disconnecting the IFT connector
    Disconnecting the IFT connector
  2. Disconnect the other connector from the system board.
  3. Carefully grasp the PCIe riser-cage assembly by its edges and remove it out of the node; then, disconnect the connector.
    Figure 2. PCIe riser-cage assembly removal
    PCIe riser-cage assembly removal
  4. Grasp the adapter by its edges and carefully pull it out of the PCIe riser-cage.
    Figure 3. IFT adapter removal
    IFT adapter removal

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.