Remove the FPC

Use this information to remove the FPC.

S002
disconnect all power
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the electrical current that is supplied to the device. The device also might have more than one power cord. To remove all electrical current from the tray (both nodes), remove the tray from the enclosure.
S038
Use eye protection
CAUTION:
Eye protection should be worn for this procedure.

Before you remove the FPC:

  1. Read the following section(s) to ensure that you work safely.
  2. Remove EMC shields.
    Figure 1. Upper EMC shield removal
    Upper EMC shield removal
    Figure 2. Lower left EMC shield removal
    Lower left EMC shield removal
  3. If you want to migrate current enclosure settings and the enclosure midplane VPD onto the new FPC, make sure you have done the following:

    1. You had performed FPC settings backup, the enlcosure VPD backup, and the midplane VPD backup procedures.

    2. Keep the old USB key which is removed from the FPC and install it onto the new FPC.

Complete the following steps to remove the FPC.

Watch the procedure. A video of the installation process is available:

  1. Rotate the latch and slide the FPC card module out of the support bracket.
    Figure 3. FPC card module removal
    FPC card module removal
  2. Press release tabs and slide the support bracket out of the enclosure.
    Figure 4. Support bracket removal
    Support bracket removal

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.