FQXSFMA0008M : DIMM [arg1] has failed the POST memory test. [arg2]

DIMM [arg1] has failed the POST memory test. [arg2]

Severity

Error

User Response

Complete the following steps:
  1. You must AC-cycle the system to re-enable affected DIMM connector or re-enable manually using F1 setup
  2. If the server has recently been installed, moved, serviced, or upgraded, verify that the DIMM is properly seated and visually verify that there is no foreign material in any DIMM connector on that memory channel. If either of these conditions is found, correct and retry with the same DIMM.(Note: Event Log may contain a recent FQXSFMA0011I event denoting detected change in DIMM population that could be related to this problem.)
  3. If problem persists, replace the DIMM identified by LightPath and/or event log entry. If this is a flash DIMM, make sure it is still under warranty before replacing it.
  4. If problem re-occurs on the same DIMM connector, swap the other DIMMs on the same memory channel across channels one at a time to a different memory channel or Processor. (check service information for this product/Install guide for population requirements for sparing/paring modes). If problem follows a moved DIMM to a different memory channel, replace that DIMM. If this is a flash DIMM, make sure it is still under warranty before replacing it.
  5. Check Lenovo support site for an applicable service bulletin or firmware update that applies to this memory error.
  6. If problem persists, collect Service Data log.
  7. Contact Lenovo Support.