Install the bulkhead

Use this information to install the bulkhead.

About this task

Attention:
Watch the procedure. A video of the installation and removal process is available:

Procedure

Install the bulkhead:
  1. Place the compute node to the up-side-down orientation.
  2. Align the bulkhead to the rear end of the compute node.
  3. Using a T8 Torx screwdriver, install the screws that secures the bulkhead to the sides of the compute node.
  4. Carefully return the node to the bottom-side-down orientation.
    Figure 1. Bulkhead installation
    Bulkhead installation
After you finish
  1. Reinstall the I/O expansion adapters. See Install an I/O expansion adapter.

  2. Proceed to complete the parts replacement. See Complete the parts replacement.