Install the flash power module

Use this information to install the flash power module on the RAID adapter.

About this task

Attention:
Note: This section only applies to RAID adapters that come with a flash power module.
Watch the procedure. A video of the installation and removal process is available:

Procedure

Install the flash power module.
  1. Feed the cable up through the flash power module holder then slide the flash power module in the holder.
  2. Connect the flash power module cable to its connector on the RAID adapter until the connector retaining clip clicks into place.
Attention: Route the flash power module cable through the notch in the holder to prevent the cable from catching on the memory module slot retaining clips.
Figure 1. Flash power module installation
Flash power module installation
After you finish
  1. Reinstall the RAID adapter to the compute node. See Install the RAID adapter.

  2. Proceed to complete the parts replacement. See Complete the parts replacement.