Remove a processor and heat sink

This task has instructions for removing an assembled processor and heat sink, known as a processor-heat-sink module (PHM), a processor, and a heat sink. All of these tasks require a Torx T30 driver.

About this task

Attention:
  • Read Safety inspection checklist and Installation Guidelines to ensure that you work safely.

  • Power off the corresponding compute node that you are going to perform the task on.

  • Remove the compute node from the chassis. See Remove the compute node from chassis.

  • Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

  • Each processor socket must always contain a cover or a PHM. When removing or installing a PHM, protect empty processor sockets with a cover.

  • Do not touch the processor socket or processor contacts. Processor-socket contacts are very fragile and easily damaged. Contaminants on the processor contacts, such as oil from your skin, can cause connection failures.

  • Do not allow the thermal grease on the processor or heat sink to come in contact with anything. Contact with any surface can compromise the thermal grease, rendering it ineffective. Thermal grease can damage components, such as the electrical connectors in the processor socket.

  • Remove and install only one PHM at a time.

  • Install the PHM starting from processor socket 1.

Note:
  1. The compute node supports one I/O expansion adapter when installed with one processor, and two I/O expansion adapters when installed with two processors. At least one I/O expansion adapter should be installed in the compute node.

  2. EDSFF drive feature requires installing two processors in the compute node.

The following illustration shows the PHM locations on system board.
Figure 1. Location of memory modules and processor sockets
Location of memory modules and processor sockets
Table 1. Location of memory modules and processors
1 Memory module slots 9–12 4 Memory module slots 1–4
2 Processor socket 2 5 Memory module slots 5–8
3 Processor socket 1 6 Memory module slots 13–16
The following illustration shows the components of the PHM.
Figure 2. PHM components
PHM components
1 Heat sink 9 Clips to secure processor in carrier
2 Heat sink triangular mark 10 Carrier triangular mark
3 Processor identification label 11 Processor ejector handle
4 Nut and wire bail retainer 12 Processor heat spreader
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor contacts
7 Processor carrier 15 Processor triangular mark
8 Clips to secure carrier to heat sink  
Note: The heat sink, processor, and processor carrier for your system might be different from those shown in the illustrations.
Watch the procedure. A video of the installation and removal process is available:

Procedure

  1. Make preparations for your compute node.
    1. Remove the compute node cover. See Remove the compute node cover.
    2. Remove the air baffle. See Remove the air baffle.
  2. Remove the PHM from the system board.
    1. Fully loosen the Torx T30 nuts on the PHM in the removal sequence shown on the heat sink label.
    2. Rotate the anti-tilt wire bails on the heat sink inward.
    3. Carefully lift the PHM from the processor socket. If the PHM cannot be fully lifted out of the socket, further loosen the Torx T30 nuts and try lifting the PHM again.
    4. Place the PHM upside down with the processor-contact side up.
      Note:
      • Do not touch the contacts on the processor.

      • Keep the processor socket clean from any object to prevent possible damages.

      Figure 3. PHM removal
      PHM removal
After you finish