Install a 2.5-inch hot-swap drive

Use this information to install a 2.5-inch drive.

About this task

Attention:
Note:

There are two 2.5-inch drive bays in the compute node. If the compute node is already equipped with one 2.5-inch drive, you can install an additional 2.5-inch drive. RAID level-0 (striping) can be configured on a compute node with a single drive installed. A minimum of two disk drives of the same interface type must be installed to implement and manage RAID level-1 (mirroring) arrays. See the ThinkSystem SN550 V2 Setup Guide for more information.

Watch the procedure. A video of the installation and removal process is available:

Procedure

  1. Locate the drive bay in which you are installing the drive.
  2. If a drive bay filler is installed in the drive bay, remove it by pulling the release lever and sliding the filler away from the compute node.
  3. Touch the static-protective package that contains the hot-swap drive to any unpainted metal surface on the Lenovo Flex System Enterprise Chassis or any unpainted metal surface on any other grounded rack component; then, remove the drive from the package.
  4. Install the 2.5-inch hot-swap drive.
    1. Keep the handle on the drive open, then slide the drive into drive bay until the drive handle catches on the bezel.
    2. Rotate the handle and secure it to the latch. The drive will be seated fully in the bay.
    Figure 1. 2.5-inch hot-swap drive installation
    2.5-inch hot-swap drive installation