To provide a redundant path to the storage array, you can configure the host to run failover.

Before you begin

You must install the required packages on your system.

  • For Red Hat (RHEL) hosts, verify the packages are installed by running rpm -q device-mapper-multipath

  • For SLES hosts, verify the packages are installed by running rpm -q multipath-tools

About this task

SLES 12 use Device Mapper Multipath (DMMP) for multipathing when using NVMe over Fibre Channel. RHEL 8, RHEL 9, and SLES 15 use a built in Native NVMe Failover. Depending on which OS you are running, some additional configuration of multipath is required to get it running properly.

Enable Device Mapper Multipath (DMMP) for SLES 12

By default, DM-MP is disabled in RHEL and SLES. Complete the following steps to enable DM-MP components on the host.

  1. Add the NVMe DE Series device entry to the devices section of the /etc/multipath.conf file, as shown in the following example:

    devices {
            device {
                    vendor "NVME"
                    product "Lenovo DE_Series *"
                    path_grouping_policy group_by_prio
                    failback immediate
                    no_path_retry 30
  2. Configure multipathd to start at system boot.

    # systemctl enable multipathd
  3. Start multipathd if it is not currently running.

    # systemctl start multipathd
  4. Verify the status of multipathd to make sure it is active and running:

    # systemctl status multipathd

Set up Native NVMe Multipathing for RHEL 8

About this task

Native NVMe Multipathing is disabled by default in RHEL 8 and must be enabled using the steps below.

  1. Setup modprobe rule to turn on Native NVMe Multipathing.

    # echo "options nvme_core multipath=y" >> /etc/modprobe.d/50-nvme_core.conf
  2. Remake initramfs with new modprobe parameter.

    # dracut -f
  3. Reboot server to bring it up with the Native NVMe Multipathing enabled

    # reboot
  4. Verify Native NVMe Multipathing has been enabled after the host boots back up.

    # cat /sys/module/nvme_core/parameters/multipath
    1. If the command output is N, then Native NVMe Multipathing is still disabled.

    2. If the command output is Y, then Native NVMe Multipathing is enabled and any NVMe devices you discover will use it.

For RHEL 9 and SLES 15, Native NVMe Multipathing is enabled by default and no additional configuration is required.