Under the guidance of technical support or as instructed by the Recovery Guru, you can check the redundancy on a volume in a pool or volume group to determine whether the data on that volume is consistent.

Redundancy data is used to quickly reconstruct information on a replacement drive if one of the drives in the pool or volume group fails.

Before you begin
Check volume redundancy only when instructed to do so by the Recovery Guru and under the guidance of technical support.
About this task

You can perform this check only on one pool or volume group at a time. A volume redundancy check performs the following actions:

Immediately running a redundancy check on the same pool or volume group might cause an error. To avoid this problem, wait one to two minutes before running another redundancy check on the same pool or volume group.
  1. From the Manage page, select the storage array with the pool or volume group.

  2. Select Provisioning  Configure Pools and Volume Groups.

  3. Select Uncommon Tasks  Check volume redundancy.

    The Check Redundancy dialog box appears.

  4. Select the volumes you want to check, and then type check to confirm you want to perform this operation.

  5. Click Check.

    The check volume redundancy operation starts. The volumes in the pool or volume group are sequentially scanned, starting from the top of the table in the dialog box. These actions occur as each volume is scanned:

    • The volume is selected in the volume table.

    • The status of the redundancy check is shown in the Status column.

    • The check stops on any media or parity error encountered, and then reports the error. The following table provide more information about the status of the redundancy check:

    Field Details
    Status Description


    This is the first volume to be scanned, and you have not clicked Start to start the redundancy check.
    The redundancy check operation is being performed on other volumes in the pool or volume group.


    The volume is undergoing the redundancy check.


    The volume passed the redundancy check. No inconsistencies were detected in the redundancy information.


    The volume failed the redundancy check. Inconsistencies were detected in the redundancy information.

    Media error

    The drive media is defective and is unreadable. Follow the instructions displayed in the Recovery Guru.

    Parity error

    The parity is not what it should be for a given portion of the data. A parity error is potentially serious and could cause a permanent loss of data.

  6. Click Done after the last volume in the pool or volume group has been checked.