The clear storageArray recoveryMode
command forces a storage array to exit recovery mode.
Supported Arrays
This command applies to an individual DE2000H, DE4000H,
DE4000F, DE6000H, or DE6000F storage array.
Roles
To execute this command on an storage array, you must have the
Storage Admin role.
Syntax
clear storageArray recoveryMode
Notes
Note: Recovery mode is entered during start-of-day operations
when the system configuration is cleared and a valid on board backup
is available. This mode is exited by either restoring the system configuration
from a backup location, or by clearing the existing on board backups.
While recovery mode is in force, a needs
attention condition is raised and the Recovery Guru
is available from the user interface. However, the system configuration
is empty during recovery mode.
Attention: If
you want to return the storage array to a previous configuration,
you must restore the configuration from the backup before clearing
recovery mode. You must perform validation checks or check with technical
support to make sure that the restore was successful. After determining
that the restore was successful, recovery mode can be cleared.