If you do not see your
connected hosts, then automatic detection has failed, the hosts are
improperly connected, or no hosts are currently connected.
You can configure hosts later,
once you are done with the setup. You can create hosts either automatically
or manually as follows:
- If you installed the Host Context
Agent (HCA) on your hosts, the HCA pushes the host configuration information
to the storage array. System Manager automatically configures these hosts and displays them in the Initial Setup wizard. (HCA does not apply to NVMe over
Fabrics hosts.)
- You can manually create hosts
and associate the appropriate host port identifiers by going to . Hosts that have been created manually also display in the Initial Setup wizard.
- The target and host must
be configured for the host port type (for example, iSCSI or NVMe over
RoCE), and a session to the storage established before automatic detection
will work.